Page Comparison

Test Plates

• BS_PLT1_Norm (4 samples)

• BS_PLT2_Norm (4 samples)

PCR MasterMix

• Add 11 ul to each well of a hard shell, full skirt plate. Add 2 uL of primers and 2uL of template to each well.

• Primers: _______________ (fill in when primers arrive).

Template Format:

Run on thermocycler program TRNL_TBSP*:

*TRNL_T BSP program will test the efficiency of the PCR/annealing temperature by running it on a temperature gradient for each row. The table below shows the annealing temperature for each row.

...

MagBead Cleanup:

Some plates were cleaned up using the Nimbus platform protocol “AxyPrep MagBead PCR1 No MM”

...

• Equilibrate Beads to room Temperature

• Add 15uL of ultra pure water to each well.

• Add 24 ul of MagBeads to each well.

• Pipette mix up and down 10 times.

• Incubate at RT for 5 minutes

• Secure plate on magnet plate; incubate at RT for 5 minutes (until wells are clear)

• Remove 65 ul from each well; keep tips to left or right depending on the column to avoid bead pellet.

• Add 100 ul Fresh 80% EtOH to each well. Incubate 30 seconds. Remove 100 ul from each well

• Add 100 ul Fresh 80% EtOH to each well. Incubate 30 seconds. Remove 100 ul from each well

• Reaspirate from each well to assure maximum EtOH removal

• Allow plate to air dry for 7 minutes.

• Remove sample plate from magnet plate.

• Add 40 ul TE; pipette mix 10+ times. Incubate 2 minutes at RT.

• Place sample plate back on magnet for 5 minutes or until all wells are cleared.

• Transfer 40 ul to labeled transparent plate (Plate name_PCR_MIDs)

qPCR

...

BSP_Test

• Make 1:1000 dilutions of column 1,2,3 and 6,7,8 from the PCR plates by adding 1 ul to 999 ul TE in a deep well plate: (Will fill in with proper sample names.)

...

• Add 4 ul of template, pool, or standards to each well:

...

...

1

...

2

...

3

...

...