...
I cannot get this to mark step as complete when I set the 2 16S or ITS plates as going into the same new barcoded plate. It just seems to stall and never mark step as complete.
This appears to be because somehow I got my earlier attempt to not error when entering the same barcode for the two plates combined into one. This time it tells me that the plate already exists. I am still stuck here
h
General
Add “Aliquot Plate” as a Protocol
Create daughter plate from any plate to carry through next steps
My CR2600 (earlier model adds a pre and post \ to each scan. Need to find out how to stop that and make it press enter.